PanelScan Integration Guide Camera and Light Mounting The camera and light must be mounted as shown below for PanelScan Standard. The Wide system uses two lights side-by-side with the cameras separated by 200 mm (8”) . Refer to the drawings provided to make a mount for the cameras and for the lights. The drawings show the recommended standoffs from the board and the angle for both the light and the camera. The camera is pointed straight down. The light is mounted at 45 degrees angling in so that the light line intersects the line scan camera’s viewing line at the board surface. This type of mounting can generally be made from various kinds of structural tubing.
Be sure to allow for side-to-side movement of the camera across the board so that it can be centered. Be sure to allow for angle adjustment of the light so that the center line of the light can be aligned to the center viewing line of the camera. • Assemble the camera by attaching the lens F-Mount adapter using the screws provided. • Screw on the lens provided. • Mount the camera on the slide as described above. • Mount the lights on the light mount as described above. • Omron Microscan recommends that you include a lens clamp to prevent vibration and to lock down the lower focus ring.
• Omron Microscan also recommends a clear lens cover for any cameras mounted below the conveyor to keep dust off the lens. PanelScan Standard Configuration 6 Copyright © 2019 Omron Microscan Systems, Inc.