When any CRS is installed, except for a booster seat without a back, it is advised that the adjustable vehicle head restraint is removed, and stowed safely. • If the driver seat obstructs or interferes with the correct installation of the child restraint system, on the rear outboard seat behind the driver, install the child restraint system on the other rear outboard seat. Child restraint installed on front passenger Child restraint installed on front passenger seat seat 02 • When using a rear-facing child seat, turn the PAB switch to OFF to disable the front passenger seat airbag.
SAFETY • For details, see PAB Switch* • Identify the appropriate anchorages and install the child restraint system. When a booster seat without a back is installed, the adjustable vehicle head restraint must remain fitted, and adjusted to the appropriate height for the seated child. When the seat position does not have any CRS or booster seat installed, the adjustable vehicle head restraint must remain fitted, and adjusted to the appropriate height for the occupant. Attach the tether strap to the anchorage, then tighten the top tether as per the instructions provided by the manufacturer of the child seat. • The rear outboard seats are equipped with ISOFIX/i-Size anchorages.
The anchorage locations are identified by a marking (see illustration) located on the seat back, directly above the associated anchorages. Make sure that the tether strap is attached securely. (1) Top straps (2) Anchorage CAUTION! •Before installing the child seat top tether, remove the trunk luggage compartment cover. •If a headrest is removed, make sure to store it safely in the luggage compartment. • The front passenger seat is equipped with a tether strap anchorage on the back of the seat. •BYD recommends installing the CRS using the ISOFIX anchorage points of the car. 27