Instruments and Controls 1 13 Warning Message Procedure Brake Fault Indicates that a fault has been detected within the braking system. Stop the vehicle as soon as safety permits, switch the vehicle power system OFF, and contact an MG Authorised Repairer immediately. Stability Control Fault Indicates that the SCS system has detected a fault. Please contact an MG Authorised Repairer immediately. Traction Control Fault Indicates that the TCS system has detected a fault. Please contact an MG Authorised Repairer immediately. Parking System Fault Indicates that the EPB system has detected a fault. Please contact an MG Authorised Repairer as soon as possible.
Park Brake Force Not Enough Indicates that the electronic parking brake system has detected a fault when parking. Please contact an MG Authorised Repairer as soon as possible. Warning Message Procedure Autohold Fault Indicates that the auto hold function has detected a fault. Please contact an MG Authorised Repairer as soon as possible. Hill Descent Control Fault Indicates that the HDC system has detected a fault. Please contact an MG Authorised Repairer as soon as possible. EPS Performance Reduced Indicates that the electric power steering system (EPS) has a general failure and the performance is reduced.
As soon as conditions permit, safely stop the vehicle and switch the vehicle power system to the OFF position. After a short while, switch the vehicle power system to the READY position, drive the vehicle a short distance and monitor the operation of the steering. If the message is still displayed or the steering assistance reduced, please contact an MG Authorised Repairer immediately. Warning Message Procedure EPS Assistance Failure Indicates that the electric power steering system (EPS) has detected a fault. Please contact an MG Authorised Repairer immediately. Steering Angle Fault Indicates that the steering angle sensor has failed.
Please contact an MG Authorised Repairer as soon as possible. Steering Angle Uncalibrated Indicates that the steering angle sensor is not calibrated. Please contact an MG Authorised Repairer as soon as possible. ESCL Fault Indicates that the ESCL has detected a fault. As soon as conditions permit, safely stop the vehicle and switch the vehicle power system to the OFF position and contact an MG Authorised Repairer immediately.