Checking clutch clearance and adjusting if necessary 3 A Inspections I, III 5 4 LT000180 • Set dimension “A” with adjusting screw at clutch hand lever. • Lock adjusting screw (5) with knurled nut (3). Dimension “A” ........ 4 ± 0.5 mm (0.157 ± 0.0197 in) e Caution: Adjust to take up wear only at the adjusting screw on the clutch release lever. • Detach clutch cable at clutch release lever (1). • Slightly push back rubber sleeve (2). • With the aid of setting gauge, BMW No. 21 3 500 ,set dimension “b” with ad- justing screw at clutch hand lever. Dimension “ B ” ..... 75 ± 1 mm (2.952 ± 0.03937 in) • Reattach clutch cable at clutch release lever.
Reading out Motronic defect code memory 7 6 Inspections II, III • Carry out this job only on motorcycles with cata- lytic converter. L Note: To read out Motronic defect code memory, see the booklet entitled: “BMW Diagnosis, Motronic 2.1 with oxygen-sensor control” (order No. 01 70 9 798 970). LT000170 • Using box spanner, BMW No. 21 3 610 ,release locknut (6) of adjusting screw (7) at clutch re- lease lever. • Unscrew adjusting screw by one to two turns, then screw in until pressure can be felt. • Lock adjusting screw with locknut. 00.18 B 1 2 LT00 LT00 0160