Checking increased starting speed (choke) and adjusting if necessary Inspections I, III Checking increased starting speed • Remove the left battery cover. • Move the increased starting speed device up to its limit stop (stage 2). e Caution: Screw (2) is secured with lacquer and must not be reset. L Note: Stop face (1) must make contact with screw (2) and the wire cable must have zero play; failing this, cable play must be adjusted. • Check stop face (1). • Move the increased starting speed device up to its limit stop (stage 2). • Loosen locknut (3). • Press the lever with stop face (1) against screw (2). • Turn adjusting screw (4) to obtain zero play in the cable. • Tighten locknut (3).
00.19 4 3 2 1 LT130030