Checking tightness of rear wheel studs Greasing the side (prop) stand pivot (Inspection I) (Inspections I, II and III) • Tighten the rear wheel studs with a torque wrench. X Tightening torque: Rear wheel studs ....................................... 105 Nm Checking rear wheel bearing play by tilting wheel (Inspection III) • Tilt the rear wheel to and fro across its axle. • If play is detected, fit new shims to rear wheel drive or renew bearings. Checking swinging arm bearings, adjusting if necessary (Inspections I and III) • Grip rear tyre and try to move it sideways, brac- ing against the frame. 00.25 C000200 • Check free movement of side (prop) stand and grease if necessary.
• Grease pivot point (arrow). Lubricant: For side (prop) stand pivot........... Shell Retinax EP2 Checking function of side (prop) stand contact switch (Inspections I, II, III and IV) • Place the motorcycle on the auxiliary stand, BMW No. 00 1 550. • Select a gear and switch on the ignition. • Slowly extend the side (prop) stand and watch the neutral indicator light. L Note: As the stand is extended, the neutral indicator light should come on briefly.