Assembling engine Installing conrod 11 2 210 RS110370 • Clamp crankshaft in a vise provided with protec- tive jaws. • Oil the big end bolts, screw them in by hand and tighten with angle gauge, BMW No. 11 2 210 . e Caution: Oil the bearings. Do not accidentally confuse conrods or bearing shells. Always use new big end bolts. Installed direction of conrods: ..lettering facing up X Tightening torque: Big end bolts (oiled) Joint torque.................................................. 20 Nm Wrench angle.................................................... 80 ° 11.45