RIEVTECH STUDIO SOFTWARE MANUAL l Off Pulse A falling edge pulse is produced which the bit address keeps the pulse “ off ” in a designated time width. The pulse width range is 0.1~1.5 second. For the “ On Pulse ” , if the pulse width is set to 1 second and the current bit state is OFF, a 1 second ON pulse signal will be produced and then it goes back to the OFF state. If the current bit state is ON, a 1 second ON time will be still set because the bit state is already ON, and then the bit state will turn OFF. Similar to the “ Off Pulse ” , if the pulse width is set to 1 second and the current bit state is ON, a 1 second OFF pulse signal will be produced and then it goes back to the ON state.
if the current state is OFF, a 1 second OFF time will be still set because the bit state is already OFF, and then the bit state will turn ON. There is an “ Action ” attribute for the Bit Set component. It includes two options, “ Press ” and “ Release ” . When the “ Bit Set ” component is pressed down, the bit set function will be executed immediately. When the “ Release ” attribute is selected and the “ Bit set ” component is pressed, the bit set function will not be executed. And when it is released, the “ Bit set ” function will be executed immediately. But the action is not valid when the “ Execute Setting ” is “ Reset ” . The “ Bit Set ” component has other property pages.
For example, in the “ Indicator Light ” property page, it is recommended to check the “ Use Indicator ” option and set an address 124