Chapter 4: Hardware Installation Insert the Appliance Into the Sliding Track Use the following procedure to insert the appliance into the sliding track. Figure 4-8. Inserting the Chassis Into the Track 1. Extend the sliding tracks [1] out on each side (about half-way). 2. Hold the chassis [2] level and square with the sliding track [1]. 3. Insert the sliding rails into the sliding tracks [3] and push the chassis [2] all the way in until you hear the sliding rails click and lock. 4. Carefully and slowly pull the chassis out again to full extension, making sure that the rail stops at the lock (See [3] in Figure 4-3. ). 5.
Push the appliance chassis in completely and secure it to the rack by inserting two M5x15 screws into the top holes on each side as shown below. Use finger tightness or torque each screw to no more than 1 ft-lb (1.4 N-m). Do not overtighten the M5x15 secur- ing screws. 20569-000 Rev. A EM2100 Installation Guide 27