Chapter 4: Hardware Installation 4.4 Connecting Power to the EM2100 The appliance requires a 100 – 240 VAC, 50/60 Hz power supply. We recommend that you use a separate uninterruptable power supply (UPS) circuit for each appliance. WARNING: ELECTROCUTION RISK . Make sure that all connections and supply equipment are operationally safe and follow all local regulations con- cerning the electrical installation of computer devices. AVERTISSMANT: RISQUE D'ЙLECTROCUTION. S’assurer que toutes les connexions et les йquipements d’alimentation sont sыrs du point de vue opйra- tionnel et respecter toutes les rйglementations locales concernant l’installation йlectrique des dispositifs informatiques. 1.
After the EM2100 appliance has been properly mounted and all necessary electrical and network connections are made, ensure the power switch (front) and main power input switch (rear) are both OFF. 2. Connect the AC plug on the rear of the appliance to AC power. 3. Set the main power input switch (rear) to ON (|). Additional Information : Use only the front momentary power switch to control AC power during normal operation. 20569-000 Rev. A EM2100 Installation Guide 29