Chapter 4: Fleet Operations Workspace Core Software System Requirements Verify that your PC meets the following requirements before installing MobilePlanner: l OS : Windows 7 (32-bit/64-bit), Windows 8 (32-bit/64-bit),or Windows 10 (32-bit/64-bit). l CPU : 1.5 GHz Dual-core (min). l RAM : 1.5 GB (min) 4 GB RAM recommended). l GPU : 256 MB (min). l HDD/SSD : At least 200 MB available space. l Monitor : XGA 1024 x 768. Installing MobilePlanner Ensure that your PC meets the system requirements, then install (or download and install) MobilePlanner. NOTE: The MobilePlanner software installs into a MobilePlanner5 directory.
This different install directory allows you to use the relevant MobilePlanner ver- sion with your fleet. Version Information: Only MobilePlanner software version 5 or higher is com- patible with FLOW Core. It is not compatible with earlier Omron fleets running on Mobile Software Suite version 4.X or earlier. 1. Use one of the following methods to download and/or install the MobilePlanner soft- ware: a. By USB drive : insert the software media (USB drive included with your AMR’s documentation) into your PC, and browse to the USB drive to locate the software. b. From SetNetGo:
When directly connected to the AMR via Ethernet, you can open SetNetGo, click the Software tab, and install MobilePlanner. c. By download: Contact your Omron representative for assistance with down- loading MobilePlanner software. 2. Launch the installer and, when the welcome screen appears, follow the prompts in each installation wizard window to complete the installation. If you used SetNetGo or downloaded the software, this will usually be in your Down- loads folder. The actual location is determined by the settings in the browser that you use. 3. Click Finish when done.
4.3 Configure the AMR’s Wireless Communications Before you can start working with your AMR, you have to configure it for wireless com- munication (via WiFi) using your PC. To do this, you will first have to connect your PC to the AMR via Ethernet cable to gain access to the AMR's wireless settings. In general, the set-up process is as follows: l Connect your PC to the AMR via Ethernet l Set your PC’s IP address 36 Fleet Operations Workspace Core User's Guide 20569-020 Rev. A