l Connect to SetNetGo l Configure the AMR’s network settings l Establish a wireless connection to the AMR NOTE: The setup steps above assume that the AMR is fully-charged, powered up, and ready. If this is not the case, please refer to your AMR’s user guide for complete setup instructions. Step 1: Connect Your PC to the AMR via Ethernet To connect your PC to the AMR (MH60/MH90 AMR shown - check the user guide for your particular AMR): 1. Open the AMR's maintenance access panel (left side, upper right corner), by pressing the access panel’s upper left corner (see image below) into the side of the AMR. Figure 4-1. Maintenance Door Location 2.
Using a standard (pass-through) or cross-over CAT-5 Ethernet cable, connect your PC directly to the AMR's maintenance Ethernet port (see below). The AMR will auto- detect the cable type. Figure 4-2. Ethernet Connection 20569-020 Rev. A Fleet Operations Workspace Core User's Guide 37