SAMI G S 7.3 Parameter Logic Note! When the power is switched on, the last parameter displayed before the unit was switched off is displayed except for Start-up Data parameters (SAMI OUTPUT FREQ will be displayed). 1 Start-up Data: 2 5 A Language B Application C Applic. Restore D Supply Voltage E Pole Number F Motor nom Current G Motor nom Power H Cos phi of Motor 4 3 2 3 15 16 + 1 Operating Data: 1 SAMI Output Freq 2 Motor Speed 3 Motor Current . . . 10 Parameter Group Main 23 Parameter Lock Figure 7-2. The parameters are divided into 3 Main and 19 Groups according to their function. In addition there are Operating Data parameters and Start-Up Data parameters.
Start-up Data are application and motor specific , which must be entered during commission- ing. The Operating Data display monitors values from the drive. Control place and parameter lock selection is made in this mode. A complete table of parameters is presented on pages 33 - 36. 23 5 4 14 1 3 1 2 11 1 20 30