SC-B9580 User's Guide Introduction Results of the adjustments are registered to the currently selected Media Settings. A Media Feed Adjustment To correct banding that occurs during printing, press this area to perform media feed corrections. If the feed amount is too small, black bands (dark stripes) appear; correct the feed amount upwards (+). In contrast, if the feed amount is too large, white bands (pale stripes) appear; correct the feed amount down‐ wards (-). The value indicates the amount of feed that has been corrected as a percentage or as a positive (+) or negative (-) value. B Feeding Tension Displays the feeding tension setting.
Press this area to change the setting if necessary, for example, if the media wrinkles during printing. C Preheat Start/Stop You can start/stop pre-heating for the heater each time you press this area. D Heater temperature The heater's current temperature is displayed on the top row, and the set temperature is displayed on the bot‐ tom row. Press this area to change the temperature. E Rewind Tension Displays the rewind tension setting. Press this area to change the setting if necessary, for example, if media is wrinkled during printing or if there is too much slack in the rewound media. F Drying Time per Pass Displays the setting for the drying time per pass.
Press this area to change the drying time. G Paper Suction Displays the setting for the strength of the suction force applied by the platen to the media. Press this area to change the setting if necessary, for example, if the media is wavy on the platen. 21