SC-B9580 User's Guide Basic Operations If the pattern is difficult to check, such as if the ink bleeds, input "0.0%" one time. A Check that the printer is ready to print, and load the media according to the actual usage conditions. In this situation, the media feed is not adjusted. Perform the following steps to complete Manual(Standard), and then perform Manual(Measurement) again. When using the auto take-up reel unit, attach the media to the take-up roll core. U “Loading Media” on page 38 When Manual(Measurement) is selected U “Using the Auto Take-up Reel Unit” on page 40 Adjustment patterns #1 and #2 are printed.
Cut after the adjustment pattern, spread it out on a flat surface, and then measure it using a scale. B Press (menu), and then press Media Settings - Print Adjustments - Manual Adjustment - Print Head Alignment . Use a scale that can measure in increments of at least 0.5 mm (0.02 in.). We also recommend using a scale that can measure at least 500 mm (20.0 in.). C Press Start . An adjustment pattern is printed. Wait until printing is complete. D Check the printed adjustment pattern. Two blocks, A and B are printed. Select the finest lined pattern (all lines overlap) for both. Select "-1" in the cases shown below.
E The screen for entering confirmation results for the adjustment pattern is displayed. When Manual(Standard) is selected Set the values printed under the patterns selected in A and B, and then press OK . When Manual(Measurement) is selected Set the values measured in step 4 for #1 and #2 respectively, and then press OK . E The screen for entering confirmation results for the adjustment pattern is displayed. When adjustments are complete, the Home screen is displayed. , enter the pattern number recorded in step 4, and then press OK . Using / Procedure for Print Head Alignment F Set the number per check pattern, and then press OK .
You can also perform this if you notice misalignment of ruled lines or graininess in the print results. 49