Precautions During Wiring Danger Do not change the wiring during the power-on process. Otherwise, it may cause electric shock or injury. Warning The wiring or inspection operation should be carried out by a professional technician. Otherwise, it may cause electric shock or product failure. Please check the wiring and power supply carefully. The output circuit may be short-circuited due to incorrect wiring or the application of a different voltage. In the event of such a fault, the brake will not operate, which may result in mechanical damage or injury to personnel. 5 SD700 Series Servo Technical Manual Please keep and install in the following environment.
Places where there is no direct sunlight Place where the ambient temperature does not exceed the product specifications Place where the relative humidity does not exceed the product specifications Place where there is no condensation due to sharp temperature difference Place where there is no corrosive gas or combustible gas Place where there are no combustible materials nearby Place where there is little dust, dirt, salt and metal powder Place where water, oil and medicine are not easily splashed Place where vibration or shock will not affect the product (place that exceeds product specifications) Place where radiation will not be received When stored or installed in an environment other than the above, the product may malfunction or be damaged Please use it in an environment that meets the product specifications.
When used in an environment that exceeds the product specification, the product may fail or be damaged. The servo unit and servo motor are precision equipment. Do not drop it or apply strong impact on it. Otherwise, it may cause malfunction or damage. Make sure that the servo unit is installed in the control cabinet. Do not block the air inlet and exhaust ports of the Servo Unit and Servo Motor with cooling fan, or allow other materials to enter the product. Otherwise, it may cause malfunction.