Example: Heat treatment (core temperature of 56° C or more for more than 30 minutes) Also, treatment must be done at the material stage before packaging, not as a whole after packaging. When packaging electrical products (stand-alone or loaded on machinery, etc.) with fumigated wood, the gases and vapors generated by the wood can be fatal to electronic components. In particular, halogen-based disinfectants (fluorine, chlorine, bromine, iodine, etc.) may cause internal corrosion of capacitors. Do not over-tighten the lifting bolts of the servo unit and servo motor. Strong tightening with implements, etc. may cause breakage of the screw holes.
Precautions During Installation Attention Install the Servo Unit and Servo Motor in a position with sufficient weight resistance in accordance with the technical data. Install the servo unit, servo motor, regenerative resistor and dynamic braking resistor on non-combustible materials. Direct installation on or near combustible materials can cause a fire. During installation, be sure to maintain the specified separation between the Servo Unit and the inner surface of the control cabinet and other machines. Otherwise, it may cause a fire or malfunction. Install the Servo Unit in the specified direction. Otherwise, it may cause a fire or malfunction.
Do not step on this product or place heavy objects on it. Otherwise, malfunction, damage or injury may occur. Do not allow other materials to enter the servo unit and servo motor. Otherwise, it may cause malfunction or fire. Notice 4 SD700 Series Servo Technical Manual