Precautions During Handling Attention Please use the correct method for handling according to the weight of the product. Do not use the lifting bolts of servo units and servo motors to carry the machinery. Failure to do so may result in injury or equipment failure. When handling the servo unit and servo motor, please pay attention to the sharp parts such as the corners of the equipment. Failure to do so may result in injury. Do not stack this product too much (Follow the instructions.), Failure to do so may result in injury or malfunction. Notice When handling the Servo Unit, do not hold the front cover and connectors. Otherwise, the servo unit may fall off.
The servo unit and servo motor are precision equipment. Do not drop it or apply strong impact on it. Otherwise, malfunction or damage may occur. Do not apply impact to the connector part. Otherwise, poor connection or malfunction may occur. If wood for packaging (including wood frames, plywood, pallets, etc.) needs to be disinfected or disinsected, be sure to use a method other than fumigation. 3 SD700 Series Servo Technical Manual Please keep and install it in the following environment.
Place where there is no direct sunlight Place where the ambient temperature does not exceed the product specifications Places where the relative humidity does not exceed the product specifications Place where there is no condensation due to sharp changes in temperature Places where there are no corrosive gases or combustible gases Place where there are no combustible materials in the vicinity Places where there is little dust, dirt, salt and metal powder Places where water, oil and drugs are not easily splashed Places where vibration or shock will not affect the product (places exceeding product specifications) Places where the product will not be subjected to radiation that could cause product failure or damage when stored or installed in environments other than the above.