VEICHI — SD700 User Manual 20230516 (EN)

 Precautions During Storage Attention  Do not stack this product too much (follow the instructions), otherwise it may cause injury or malfunction. Notice 2 SD700 Series Servo Technical Manual  Be sure to connect the ground terminal of the servo unit and servo motor to the ground pole. Otherwise, it may cause electric shock or fire.  Do not disassemble, repair or modify the product. Otherwise, it may cause a fire or malfunction. Disassembled, repaired or modified products are not covered by the warranty. Attention  The heat sink of the servo unit, regenerative resistor servo motor, etc. may be at high temperature when the power is turned on or just after the power is turned off.

Please take safety measures such as installing an outer cover to avoid accidental touching of hands and parts (cables, etc.). Otherwise, it may cause burns.  Do not damage or pull the cable by force, or subject the cable to excessive force, place it under heavy objects or cause it to be clamped. Otherwise, it will cause malfunction, damage, and electric shock.  Do not use the product in places where water can be splashed, in corrosive environments, in flammable gas environments, or near combustible materials. Otherwise, it may cause electric shock or fire. Notice  Do not use servo units and servo motors that are damaged or have missing parts.

 Set up an emergency stop circuit externally to ensure that power is cut off and operation is stopped immediately in the event of an abnormality.  If the Servo Unit is used under poor power conditions, install protection equipment (AC reactor, etc.) to ensure that the input power is supplied within the specified voltage variation range. Otherwise, the servo unit may be damaged.  Use a noise filter, etc. to reduce the influence of electromagnetic interference. Otherwise, electromagnetic interference may be caused to electronic equipment used near the servo unit.  Use the Servo Unit and Servo Motor in the specified combination.  Do not touch the servo unit and servo motor with wet hands.

Otherwise, the product may malfunction.