This warranty g Yes you specif c egal rights, and you may also have other rights which vary from State to state; _ SEARSI ROEBUCK AND CO., DEPT. 69B/731A Sears ToWer. Chicago, IL 60684 Before =operating the Recreator read and understand your Router and Router Recreator owner's manuals and affixed warnings. The General Safety Instructions which follow apply to your Router and Router Recreator co mbinaUon as a "power tool." genera!l safety instructions for power tools 1. KNOW YOUR POWER TOOL Read and understand the owner's manual and 12. labels affixed to the tool Learn its application and limitations as well as the specific potential hazards peculiar to this tool. 2.
GROUND ALL TOOLS UNLESS USE SAFETY GOGGLES Safety goggles must comply with ANSI Z87.1-t968, Also use face or dust mask if cutting operation is dusty. Everyday eyeglasses only have =mpact resistant lenses, they are not safety glasses. SECURE WORK Use clamps or a vise to hold work when practical, it's safe r than using your hand, frees both hands to operate toot. DOUBLE INSULATED 13. If tool is equipped with an approved 3-conductor cord and a 3--prong grounding type pug to fit the proper grounding type receptacle. The green conductor in the cord is the grounding wire. Never: connect the green 14. wire to a live terminal DON'T OVERREACH Keep proper footing and balance at all ttmes. 15.
MAINTAIN TOOLS WITH CARE Keep tools sharp and clean for best and safest performance. Follow instructions for lubrication and changing accessories. DISCONNECT TOOLS before servicing; when changing accessories Such as blades, bits, cutters, _tc. 3, KEEP GUARDS iN PLACE and in working order. 4. REMOVE ADJUSTING KEYS AND WRENCHES Form habit of checking to seethat keys and 16. adjusting wrenches are removed f,rom tool before tui'ning it on. : i :- : 5; KEEP WORK AREA CLEAN : 17. Cluttef;ed areas and benches nv te accidents. Ftoor must not be slippery dueto wax: or sawdust. --18. 6, AVOID DANGEROUS ENVIRONMENT Don't use power tools in damp or wet location. Keep work area well lit.
Provide adequate surrounding work space. 7. KEEP CHILDREN AWAY 19. AH visitors should be kept a safe distance from work area, 8. MAKE WORKSHOP KID-PROOF -- with padlocks, master switches, or by removing starter keys. 9. DON'T FORCE TOOL It wit! do the job better and safer at the rate for which it was designed. 10. USE RIGHT TOOL Don't force tool or attachment to d o a job it was not designed for. WEAR PROPER APPAREL No loose clothing, g oves, neckties or jewelry to get :caught in moving, parts. Rubber-soled damaged should footwear is recOmn_ended fop best footing replaced. AVOID ACCIDENTAL STARTING Make sure switch is in "OFF position before plugging in.
USERECOMMENDED ACCESSORIES Consult the owner's manual for recommended accessories. Follow the instructions that accompany the accessories. The use of tmprope_" accessories may cause hazards. NEVER STAND ON TOOL Serious injury could occur if the toot is tipped or if the cutting tool is accidentally contacted. Do not store materials above or near the tool such that it is necessary to stand on the tool to reach them. 20.
CHECK DAMAGED PARTS Before further use of the tool, a guard or other part that is damaged should be carefully checked to ensure that it will operate properly and perform its intended function, Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting, and any other conditions that may affect its operation. A guard or other part that as be properly repaired or