i operat on iATIVE EDGING A molded or decorative-edge can be added to most rectangular shaped pieces of stock with your " Recreator, a decorative edging bit and the router work arbor set; i : Set the two inner shelf boards as prescribed for sign making, Check :for parallelism between the Recreator and the workpiece by us ng the pilot section of the work arbor. A. Touch the pilot to the edge of the workpiece at the front of the Recreator. B.-C-clamp the work_)iece to the shelf board and set both left and right hand shaft collars. C. Move the yoke assembly to the rear. Shift the rear of the workpiece until it also strikes the pilot section of the work arbor.
C-clamp the rear of the workpiece to the shelf board. \ WORK ARBOR PILOT D. The depth of cut will be controlled by thestylus riding on the back up board located on the left of the Recreator. You will note that variations in the molding can be obtained by altering the depth of cut or by setting the workpiece slightly away from the pilot of the work arbor. Shaping cross grain can also be accomplished with the aid of the shaft lock brackets. OLE IN SHAFT BRACKET LACED OVER END OF PULLEY SHAFT