Jld now be pbsSible to rotate the workpiece by L9/16 wrench on theHex head bolt located center wobble should be etectable. If the spindle :is not secure in its mounting do not attempt to operate until the necessary adjustments have been made. Mount the sketch on the back up board which is installed on the left side of the Recreator. Install a 1/4 inch stylus in the stylus mount. Select a bit desired for the first cut and secure it in the router chuck. Move the yoke assembly on the pulley shaft until the bit is approximately 1/4 inch off the centertine of the spindle to the left.
Lock the right hand putley shaft collar against the yoke bearing to serve as a stop, f ROTATE t" COUNTER CLOCKWISE f / / / Rest the router bit on the spindle and check for perpendicularity. If adjustments are required loosen the tilt plate wing nuts and square as necessary. Re-tighten the tilt plate wing nuts. Holding the stylus tip in contact with the back-up board during the operation,tu rn the router on. using a 9/16 box end wrench, Begin rotating the spindle "counter clockwise" s_multaneousty start moving the bit into the s pindle until it stops against the right hand shaft collar.
Move the bit to the area of the first cut as determined by the drawing or template and lock the pulley shaft at that location with the pulley shaft locks and wing n uts. After the cut is completed (usually several revolutions of the spindle), back the bit away from the spindle and turn the router off. Move to the next desired location and repeat above procedure. Set the depth of cut by raising the stylus above the back up board the desired amount. Move the router bit tothe left of the spindle making sure it is clear of the spindle. To create axia cuts, those running along the length of the spindle mount the spind e as indk_ated above then:
Move the router bit to the centerline of thespindte and lock the yoke at this setting by securing both left hand and right hand shaft collars. Set the depth of cut usi ng the stylus and the back up board as a guide. C-clamp the work mount to the front shelf board to prevent _t from rotating. Liftthe bit clear of the spindle, turn tt_e router on and lower the bit into the spindle. J Move the yoke assembly back and forth until thecut is €ompleted, Veins deeper than 1/8 of an inch should be made in successive cuts of 1/8 inch. / jjj i L C-CLAMP WORK MOUNT_ TO PREVENT ROTATION O