TO ADJUST MOTION CONTROL LEVER (See Fig. 29) The motion control lever has been preset at the factory and _ adjustment should not be necessary.
TO ADJUST STEERING WHEEL ALIGNMENT If steering wheel crossbars are not horizontal (left to right) when wheels are positioned straight forward, remove steer- ing wheel and reassemble per instructions in the Assembly section of this manual° If for any reason the motion control lever will not hold its position while at a selected speed, it may be adjusted at the friction pack located on the dght side of transmission° FRONT WHEEL TOE-IN/CAMBER ° Park tractor on level surface, Stop tractor by turning ignition key to 'OFF" position, and engage parking brake° The front wheel toe-in and camber are not adjustable on your tractor.
If damage has occurred to affect the front wheel toe-in or camber, contact your nearest authorized service center/department. . Adjust motion control lever by tightening adjustment locknut one half (1/2) tumo TO REMOVE WHEEL FOR REPAIRS (See Fig. 30) Block up axle securely. NOTE: If for any reason the effort to move the motion control lever becomes too excessive, reverse the above adjustment procedure by loosening locknut 1/4 to I/2 turn. Road test tractor after adjustment and repeat procedure if necessary.
Remove axlecover, retaining ring and washersto allow wheel removal (rear wheel contains a square key - Do not iose),, TRANSMISSION REMOVAL/REPLACEMENT Repair tireand reassemble_ - On rear wheels only: align grooves in rear wheel hub and axle_ Insert square key Should your transmission require removal for service or replacement, it should be purged after reinstallation and before operating the tractor. See "PURGE TRANSMIS- SION" in the Operation section of this manual. . Replace washers and snap retaining ring securely in axle groove. ,, Replace axle cover_ RETAINING RING WASHERS AXLE COVER ! ADJUSTMENT LOCKNUT _ SQUARE KEY (REAR WHEEL ONLY) FIG. 30 FIGo 29 25