S AND ADJUSTMENTS TO START ENGINE WITH A WEAK BATTERY (See Fig. 31) TO REPLACE HEADLIGHT BULB ,i , ii J,,J ° Raise hood_ CAUTION: Lead-acid batteries gener- ate explosivegases_ Keepsparks,flame and smoking materials away from bat- teries. Always wear eye protection when around batteries° iii I II IIII IIIIIIIII IIIII o Pull bulb holder out of the hole in the backside of the grill° ° Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill. Close hood. If your battery is too weak to start the engine, it should be recharged° If "jumper' cables" are used for' emergency starting, follow this procedure: IMPORTANT:
YOUR TRACTOR tS EQUIPPED WITH A 12 VOLT NEGATIVE GROUNDED SYSTEM THE OTHER VEHICLE MUST ALSO BE A 12 VOLT NEGATIVE GROUNDED SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES. INTERLOCKS AND RELAYS Loose or damaged widng may cause your tractor to run poorly, stop running, or prevent it from starting° ° Check wiring. See electrical widng diagram in the Repair Parts section of this manual.
TO REPLACE FUSE TO ATTACH JUMPER CABLES - , Connect each end of the RED cable to the POSITIVE (+) terminal of each battery, taking care not to short against chassis,_ ° Connect one end of the BLACK cable to the NEGA- TIVE (-) terminal of fully charged battery_ ° Connect the other end of the BLACK cable to good CHASSIS GROUND, away from fuel tank and battery., Replace with 30 amp autornotive-type plug-in fuse. The fuse holder is located behind the dash. TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 32) Raise hood_. Unsnap headlight wire connector_ Stand infront oftractor. Grasp hood at sides, tilt toward engine and lift off of tractor.
TO REMOVE CABLES, REVERSE ORDER - ° BLACK cable first from chassis and then from the fuliy charged battery. ° RED cable last from both batteries_ To replace, reverse above procedures. POSITIVE TERMINAL NEGATIVE TERMINAL HOOD HEADLIGHT WIRE CONNECTOR CHASSIS CABLES FIG. 32 CHARGED BATTERY POSITIVE TERMINAL NEGATIVE TERMINAL FIG. 31 26