Table 7-6. Numerical Printer Messages (continued) Control Panel Message Event Log Message Explanation Recommended Action 68 NVRAM ERROR CHECK SETTINGS An error occurred in the printer’s nonvolatile memory (NVRAM) and one or more printer settings has been reset to its factory default. 1. Print a Configuration Page and check the printer settings to determine which values have changed. 2. Hold down [Cancel Job] while turning the printer on. This will clean up the NVRAM by removing old areas that are not being used. 68 NVRAM FULL CHECK SETTINGS An error occurred in the printer’s nonvolatile memory (NVRAM) and one or more printer settings has been reset to its factory default. 1.
Print a Configuration Page and check the printer settings to determine which values have changed. 2. Hold down [Cancel Job] while turning the printer on. This will clean up the NVRAM by removing old areas that are not being used. 69.X PRINTER ERROR A temporary printing error occurred. X Description: 0 = The Duplex mechanism has failed 1. Turn the printer off, and then turn the printer on. 2. Reseat the Duplexer. 7-40 Troubleshooting