Control panel 1 There are four sliding tabs at the top of the control panel. The second tab from the right locks into place. Use a small screwdriver to press down on the locking portion of the snap-fit retaining the tab (callout 1) and slide the control panel to the right. 21 Figure 38. Removing the control panel 2 Lift out gently. Disconnect the cable from the back of the control panel. To reinstall Bias the control panel to the right until the four tabs are inserted. Then slide the control panel to the left to lock in place. Make sure the snap fit locks at the same tab shown above. EN Scanner assemblies 125