en In some cases it is adequate to switch off the appliance for 5 minutes. If the temperature is too high wait a few hours and check whether the temperature has approached the set value. If the temperature is too low check the temperature again the next day. The light does not function. Fig. 1 /13 Light switch is sticking. Check whether the light switch can move. Fig. 1 /11 Connect mains plug. Check whether the power is on, check the fuses. Showroom mode is switched on. Hold down alarm button 2 /5 for 10 seconds until an acknowledgement signal sounds. After a short time check whether your appliance is cooling. 19 Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following information. Customer service will charge you for advice – even if the appliance is still under guarantee! Do not exceed max. freezing capacity. Appliance opened frequently. Do not open the appliance unnecessarily. The light is defective. See chapter “Light”. Remove obstacles. Fault Possible cause Remedial action Eliminating minor faults yourself Displays do not illuminate. Power failure; the fuse has been switched off; the mains plug has not been inserted properly. The ventilation openings have been covered. Large quantities of fresh food are being frozen. Temperature differs greatly from the set value.
The temperature in the freezer compartment is too warm. Appliance is not cooling, temperature display and light are lit.