TEPLODOM e200 Electric Truck Manual (EN)

SPECIFICATION SHEET 21.0” 8.7” 46.5” e200 Full-electric refrigeration unit for medium-sized vans and trucks Designed for both electric and engine-powered vehicles, the e200 can help ensure your operations remain compliant with a growing array of regional and national regulations concerning the reduction of noise and CO2 emissions. The e200 provides a unique mix of control, convenience, utilization, and reliability to enhance your performance across urban settings and last-mile deliveries.

STANDARD FEATURES OPTIONAL FEATURES Fully integrated major components Door switch Enhanced controller Delector, large cover Operates with both electric and engine-powered vehicles 4M extension kits 115V shorepower Shorepower capable Cover Hose kits Lower GWP refrigerant www.thermoking.com

Стр. 1

e200 SYSTEM PERFORMANCE REFRIGERATION CAPACITY (System net cooling capacity at 100°F ambient) Heat BTU/hr Engine Power BTU/hr Standby BTU/hr ___________________________________________________________________________________ 35°F 2,300 4,700 4,700 ___________________________________________________________________________________ 0°F 2,300 2,700 2,700 EVAPORATOR: ES150 ___________________________________________________________________________________ Airflow Capacity 470 CFM COMPRESSOR: HERMETIC VARIABLE SPEED REFRIGERANT:

R-452a ___________________________________________________________________________________ Charge 2.8 lbs SYSTEM WEIGHT ___________________________________________________________________________________ Condenser 86 lbs ___________________________________________________________________________________ Evaporator ES150 31 lbs ELECTRIC STANDY OPTIONS 115V/1 Phase/60 Hz 14A ___________________________________________________________________________________ ___________________________________________________________________________________ 230V/1 Phase/60 Hz 7.5A EVAPORATOR DIMENSIONS ___________________________________________________________________________________ Inches (L x W x H) 29.7 x 21.3 x 7.4 CONDENSOR DIMENSIONS ___________________________________________________________________________________ Inches (L x W x H) 46.5 x 21.0 x 8.7 e200 Vehicle Alternator Requirements and Guidelines In addition to the vehicle power requirements, the e200 requires 115 amps from the vehicle alternator to operate at full capacity.

For many applications, a 250amp alternator on a vehicle will be sufficient to support e200 operation; this may be an upgrade to the standard alternator offering. For best results, this should be available even at idle, at which point the alternator will have approximately 60-75% of the rated power available. It is important that you work with your Thermo King Dealer and truck dealer to review your route profile and ensure the vehicle alternator has ample power to support e200 operation. *Requirements assume >3” insulation, ten door openings per delivery day in average ambient temp of 90F with standard commercial van. *This information provides general guidance only.

Body builder guidelines prevail and installation needs to strictly follow these guidelines in all cases. Thermo King is not liable if the installation does not adhere to the respective Body Builder guidelines. TK 56913-18-PL (08-24) © 2024 Trane Technologies All rights reserved. www.thermoking.com

Стр. 2