Chapter 4 Handling GS1 DataBar Omnidirectional/GS1 DataBar Truncated/GS1 DataBar Limited ❏ The first application identifier ‘01’ is not included in the data. ❏ When printing the HRI characters, the first application identifier ‘01’ is printed as ‘(01)’ before the packing identification code. ❏ A check digit need not to be attached to the barcode data. ❏ When printing the HRI character, a check digit is printed after a product code. ❏ For GS1 Databar Limited, specify ‘0’ or ‘1’ for the first digit. GS1 DataBar ExpandedM ❏ Specify the data of 38 to 66 digits that does not include ‘*’. ❏ ‘()’ is the delimiter for the application identifiers.
(printed as the HRI character, but not encoded.) ❏ When FNC1 is not at the end of the data followed by the application identifier ‘(10)’ or ‘(21),’ FNC1 is auto- matically added. ❏ When FNC1 is not at the end of the data followed by the application identifier ‘(30)’, FNC1 is automatically added. ❏ FNC1 must not be at the end of the data followed by the application identifier ‘(10)’ or ‘(21)’. In this case, an error occurs. ❏ When ‘(01)’ is specified as the application identifier, the 14th digit becomes a check digit. When the check digit is not correct, an error occurs. (Unlike GS1-128, the check digit is not automatically calculated, nor replaced with ‘*.’) ❏ '*’ is skipped.
4 ❏ When the character right after ‘{‘ is not ‘1,’ an error occurs. ❏ Specify the special character using the following format. 169 Control Character ASCII HRI Character FNC1 {1 Space is printed. ‘(’ {( '(‘ is printed. ‘)’ {) ‘)’ is printed. Left parenthesis for the application identifier ( '(‘ is printed. Right parenthesis for the application identifier ) ‘)’ is printed. ‘*’ {* '*’ is printed. Skipped character * Not printed.