Black Mark Die-cut Label / Fanfold paper Top margin (inside the label): 2.0 mm {0.079"} (typical value) Left and right margin (inside the label): 2.0 mm {0.079"} (typical value) Bottom margin (inside the label): 2.0 mm {0.079"} (typical value) 0.5 to 1.0 mm {0.02 to 0.039"} 0.5 to 1.0 mm {0.02 to 0.039"} Paper feeding direction Center of paper width Auto-cut position Perforated line Interval of perforated lines: 203.2 to 304.8 mm {8 to 12"} Auto-cut position Auto-cut position Perforated line Print area 2.0 mm {0.079"} Edge cutoff 2.0 mm {0.079"} {0.079"} Label area Backing paper • Make sure to adjust perforated lines to an integral multiple of issuing pitch.
• The perforated line and print area overlap each other to destabilize printing or perforated line and the auto-cut position are misaligned to shorten the life of the autocutter if paper without black marks is used. Use paper with black marks on the back of the paper to adjust the paper position. 52 ne e Paper width 0.5 to 2.0 mm {0 0.5 to 1 2.0 mm {0.079"} Print area width 2.0 mm {0.079"} Edge cutoff 2.0 mm