Chapter 3 Handling Paper Loading Settings Follow the steps below to specify the settings for paper loading at power-on/paper cover close. The following types are available for the settings for paper loading at power-on/paper cover close. (The type is set to [Paper feed for positioning (With cutting)] by default. If you use the default setting, there is no need to change the settings.) Paper loading at power-on 3 117 Settings Description Paper feed for positioning (With cutting) Paper loading settings:
Die-cut label (Blackmark), Continuous paper (Blackmark), Die-cut label (Gap)/Transparent die-cut label Paper is loaded based on the upper end of black mark/label detected by the black mark detecto r or label detector. After paper feed is finished, autocut is performed and the printer enters th e standby status. Paper loading settings: Full-page label/Continuous paper/Transparent full-page label A certain amount of paper is fed. After paper feed is finished, autocut is performed and th e printer enters the standby status. Paper feed for positioning (Without cutting) Paper loading settings:
Die-cut label (Blackmark), Continuous paper (Blackmark), Die-cut label (Gap)/Transparent die-cut label Paper is loaded based on the upper end of black mark/label detected by the black mark detecto r or label detector. After paper feed is finished, no autocut is performed and the printer enters th e standby status. Paper loading settings: Full-page label/Continuous paper/Transparent full-page label A certain amount of paper is fed. After paper feed is finished, no autocut is performed and th e printer enters the standby status. No paper feed for positioning No paper loading or paper feeding is performed.