English Buttons PAPER FEED PAPER FEED feeds the roll paper or the cut sheet. Note: Paper cannot be fed using this button in the following cases: • The printer cover is open. • Printer is in the cut sheet insertion or removal state. • When head cleaning is being performed or an error has occurred with any sheet selected. • When check is selected as print sheet. CLEANING If printing becomes faint or uneven and the INK LED is not on or flashing, use this button to clean the print head. Press the button more than 3 seconds. When the cleaning stops, the printer is ready for normal printing. Note: Do not use the CLEANING button unless there is a problem with print quality.
Unnecessary cleaning will waste ink. Power Switch and Power Switch Cover The power switch is on the front of the printer. Press the power switch to turn on the printer. To maintain print quality (by capping the print head), be sure to follow these instructions for turning off the power: Wait at least 8 seconds after printing on roll paper or after removing a cut sheet; then turn off the power switch. Note: Never open the printer cover or turn off the printer when the POWER LED is flashing. Power Switch Cover You can use the enclosed power switch cover to make sure that the power switch is not accidentally pressed. Just press the cover into place to install it.
If you need to turn the power switch on or off with the cover attached, you can insert a thin tool into one of the holes in the cover to operate the switch. See illustration C. WARNING: If an accident occurs when the power switch cover is attached, immediately unplug the power supply cable to avoid fire. If you are going to store the printer or leave it unused for a long time, turn it off using the power switch on the printer. TM-J7000/J7100 – TM-J7500/J7600 User’s Manual 5