TM-L90/TM-L90 Peeler Model Technical Reference Guide 5. To fine tune the amount of remaining paper that is detected by the N.E. detector, move the N.E. detector holder shown in the illustration "N.E. Detector Holder" on page 27 and adjust the position. Note: Note that the direction to move the roll paper N.E. detector varies depending on the method of printer installation (vertical/horizontal). Adjustment direction for vertical installation N.E. detector holder Adjustment direction for horizontal installation N.E. Detector Holder Holder Position #1 for horizontal Holder Position #2 for horizontal Holder Position #1 for vertical Holder Position #2 for vertical Adjustment Positions of N.E.
Detector Setup 27 Adjustment Position Number Specified Thermal Paper Dimension #1 Approximately 36 mm {1.42"} #2 Approximately 41 mm {1.61"}