Appendix Printing and Cutting Positions Last line of a previous receipt Manual-cutter position Approx. 29 Approx. 15 Autocutter blade position Center of the print dotline Printable area Paper feed direction [units: mm (All the numeric values are typical.)] • The values above may vary slightly as a result of paper slack or variations in the paper. Take this into account when setting the cutting position of the autocutter. • When removing cut paper, the remaining roll paper is pulled at the uncut section and the pitch of the next print may be reduced. When printing after cutting paper for prints with no pitch reduction, feed the paper about 1 mm {16/406 inches} before printing.
• When leaving paper loaded for an extended period of time, make sure you feed about 30 mm of paper. This can prevent paper from wrinkling and causing prints to be too light. 121