Paper Specifications • Paper must not be pasted to the roll paper spool. • The remaining amount of the roll paper when a roll paper near-end is detected differs depending on the spool type. • Use of thermal paper with a pre-printed recording surface should be avoided. Using it can cause the thermal head to stick to the thermal paper surface during printing, and cause printing failure and other problems. The pre-printing also can result in reduced print density.
Using thermal paper with a pre-printed recording surface, pre-printing should be done in accordance with the conditions (ink type, printing and other conditions) recommended by the paper manufacturer, and the thermal paper should be checked to ensure that there is no faulty printing, loss of print density, or other problems. 122 Paper types Specified thermal paper Form Roll paper Size Roll paper diameter Roll paper spool Roll width when taken up Paper width Paper thickness 83 mm {3.27"} maximum Inside: 12 mm {0.47"}, Outside: 18 mm {0.71"} 80 mm width paper printing: 80+0.5/-1.0 mm 58 mm width paper printing: 58+0.5/-1.0 mm 80 mm width paper printing: 79.5±0.5 mm 58 mm width paper printing:
57.5±0.5 mm Maximum of 80 μm, minimum of 48 μm Specified original paper type P30521, P30523, P31523, P35524 (Kanzaki Specialty Papers) AF50KS-E (Jujo Thermal Oy) F5041 (Mitsubishi HiTec Paper Flensburg GmbH) KT55FA, KT48FA (Koehler Paper Group) Epson Certified Media List for Thermal Receipt Printers https://support.epson.net/publist/bsredirect.php?code=M001035