6 Parameter Table ENGLISH I80E-EN J1000 Quick Start Guide 23 Par. Name Description Stall Prevention L3-01 0 Stall Prevention Selection during 1 Accelera- tion :Disabled - Motor accelerates at active acceleration rate and may stall with too heavy load or too short accel time. :General Purpose - Hold acceleration when current is above L3-02. L3-02 Stall Prev. S Level dur- v ing Accel. ets the current level for stall pre- ention during acceleration. L3-04 0 Stall Prev. Selection 1 during Decel. 4 :Disabled - Deceleration as set. OV might occur. :General Purpose - Deceleration is hold if DC bus voltage rises high. :Overexciation Deceferation L3-05 0 Stall Prev.
Selection 1 during Run 2 :Disabled - Motor stall or overload might occur. :Decel Time 1 - Reduce speed using C1-02. :Decel Time 2 L3-06 Stall Prev.S Level dur-p ing Run o ets the current level at which stall revention during run starts to perate. Monitor Description U1-01 Frequency Reference (Hz) U1-02 Output Frequency (Hz) U1-03 Output Current (A) U1-06 Output Voltage Reference (Vac) U1-07 DC Bus Voltage (Vdc) U1-10 Input Terminal Status : ON : OFF Reserved 1: Digital input 1 (terminal S1 enabled) 1: Digital input 2 (terminal S2 enabled) 1: Digital input 3 (terminal S3 enabled) 1: Digital input 4 (terminal S4 enabled) 1:
Digital input 5 (terminal S5 enabled) Monitor Description U1-11 Output Terminal Status : ON : OFF Reserved 1: Relay Output (terminal MA-MC closed MB-MC open) U1-13 Terminal A1 input level Fault Trace U2-01 Current Fault U2-02 Previous Fault DI/DO Sel. Description Digital Input Function Selections 3 Multi-step speed reference 1 4 Multi-step speed reference 2 5 Multi-step speed reference 3 6 Jog frequency command (higher priority than multi-step speed reference) 7 Accel/decel time selection 1 F Not used (Set when a terminal is not used) 14 Fault reset (Reset when turned ON) 20 to 2F External fault; Input mode: N.O. contact / N.C. contact, Detection mode:
Normal/during operation Digital Output Function Selections 0 During Run (ON: run command is ON or volt- age is being output) 1 Zero Speed 2 Speed Agree 6 Drive Ready E Fault F Not used 10 Minor fault (Alarm) (ON: Alarm displayed)