*ONLY available for 6-volt lead-acid batteries, as Wet Cell, Gel Cell, Enhanced Flooded, Mainte nance-Free. Consult the battery manufacturer before using this mode. EN **ONLY available for 12-volt lithium-ion batteries, including lithium iron phosphate. Consult the lithium battery manufacturer before charging and ask for recommended charging rates and voltages. Lithium-ion batteries are made and constructed in different ways. Some lithium-ion batteries may be unstable and unsuitable for charging. 3. Connecting to the Battery The below instructions are for a negative ground system (most common).
If your vehicle is a positive ground system (uncommon), follow the below instructions in re verse order: 1) Connect the positive (red) battery clamp or eyelet terminal connector with the positive battery terminal, which is typically marked by “POS, P, +”. 2) Connect the negative (black) battery clamp or eyelet terminal connector with the negative battery terminal, which is typically marked by “NEG, N, -”, or with the vehicle chassis. 3) Connect the battery charger’s AC power plug into a suitable electrical outlet.
4) Disconnect the battery charger in the reverse sequence, removing the negative first (or 8 9 Mode Explanation 12V Cold/AGM (Small) • For charging 12-volt batteries in cold temperatures below 14ºF (-10ºC) or AGM batteries. • For batteries with small capacity,which is less than 50Ah. • White LED will illuminate. 6V Norm* • For charging 6-volt Wet Cell, Gel Cell, Enhanced Flooded, Maintenance-Free. • White LED will illuminate. 12V Lithium** • For charging 12-volt lithium-ion batteries, including lithium iron phosphate. • White LED will illuminate.
12V Repair & Engine Pulse Charging • An advanced battery recovery mode for repairing and storing, old, idle, damaged, stratified, or sulfated batteries. • White LED will illuminate.