3.2 Plug the UltraDiag VCI into the Vehicle's DLC Take the UltraDiag VCI out from the back slot of the UltraDiag tablet and plug it into the vehicle's DLC. The vehicle's DLC port is usually located under the dashboard. If you encounter a problem in locating the DLC, please go to Library > DLC Location for more details, or refer to the vehicle's service manual. Car OBD-II Interface Figure 3-7 Note: Make sure the ignition is always OFF before plugging in the UltraDiag VCI.
3.3 Turn the Ignition to the "ON" Position (see Figure 3-8) If your vehicle is equipped with a keyless start system and the ignition switch is an "Engine Start Stop" button (see Figure 3-9), press the "Engine Start Stop" button until the car is in "ON" mode. Do not apply the brake while pressing the "Engine Start Stop" button, or you will start the car instead of putting it in the "ON" position. The method of ignition varies by vehicle model. Refer to the vehicle's service manual for details. 12