check of your vehicle. Performing Auto Scan before and after repair could help in troubleshooting and validating repairs. Pre and post scan reports can allow you to record the condition of the vehicle before and after repair for comparison. To perform an Auto Scan, tap Auto Scan at the bottom corner. The UltraDiag tablet will start scanning all the systems supported by the vehicle, and DTC retrieval will be automatically proceeded. Results are displayed progressively as the systems are scanned. Figure 4-4 Button Description Clear DTCs - tap to clear all the DTCs retrieved. Report - tap to save the current scan results in report format.
(To view the saved reports, go to Folder > Reports > System Report ) Show All / Show Actual - tap to toggle between showing all vehicle systems and showing only the supported systems. Performing Individual System Diagnostics Apart from Auto Scan, you can also select an individual system to perform Read DTCs, Clear DTCs, Read Data Stream, Read ECU Information and Active Test for that particular system. Note: Depending on the vehicle make, some functions may not be available. 21