User Manual of EM730 Series Inverter ★ Some parameters of the current series are reserved, and their readings are 0. Some options of parameters are reserved and settable, but this may result in abnormal operation of the inverter. Please avoid misuse of such parameters. The table below provides the details of the function code table. 70 Function code F00.00 to F99.99: function code number Function code name Full name of the function code. “Reserved” means that the corresponding function code is temporarily reserved and has no practical meaning. Parameter description Brief description of the function code. It is mainly divided into the following three types:
Integral The value of the integral function code represents the current parameter selection or meaning. Quantifier The ones, tens, hundreds, thousands and tens of thousands represent one option or the current meaning of the function code. Binary Each binary bit represents one option or the current meaning of the function code. Unit Metric units of the function code. The units and abbreviations are as follows: Hz Hertz kW kilowatt us Microsecond kHz Kilohertz kWh Kilowatt-hour★ ms Millisecond % Percent★ MWh Megawatt hour s Second V Volt mΩ Milliohm min min A Amp mH Millihenry h h rpm rpm ℃ °C m m ★: %: The benchmarks are different for physical quantities; kWh:
Kilowatt hour, commonly known as the degree. Default setting Function code settings before delivery, or values after parameter restoration (F12.14=1). This is mainly described by the following three categories. Number (e.g. 50.00) Refer to each power segment. The function code is set to the current value by default. Depending on the motor type The default setting of this function code varies based on the power segments. XXX The default setting of this function code varies based on the power segments and batches.