User Manual of EM760 High-Performance Inverter F00.03=3: the terminal RUN is for running, Xi for stop and F/R for forward/reverse control. The terminal RUN is normally ON for running, with the valid pulse edge, F/R for forward/reverse switching (forward in the OFF status and reverse in the ON status), and Xi is normally OFF for stop, with the valid level. When the mode of deceleration to stop (F04.19=0) is selected, the logic diagram is as shown in figure (d) below. (a) Wiring diagram of three-line control (F00.03=2) (b) F04.19=0, F00.03=2: forward/reverse running logic (c) Wiring diagram of three-line control (F00.03=3) (d) F04.19=0, F00.03=3: forward/reverse running logic Fig.
6-2 Three-line control The three-line control logic of the EM760 series inverter is consistent with the conventional electrical control. The keys and knob switches should be used correctly as shown in the schematic diagram. Otherwise, operation errors maybe caused. 6.1.3 Start/stop via communication control F00.02=2: communication control The inverter start and stop are controlled by the host through the RS485 communication port. See 10.3.4 Register address distribution 7000H control description for details.
6.2 Frequency command 6.2.1 Options of frequency source The set mode of the inverter refers to the physical quantity that is taken as the controlled target when the inverter drives a motor. Speed setting mode with the motor speed as controlled target Digital setting, analog input setting, high-speed pulse input setting, communication setting, digital potentiometer setting, process PID setting, simple PLC setting or multi-segment speed setting can be performed separately or in a mixed manner. The figure below details the various input modes ofthe EM760 series inverter by speed setting: 75