c. If both of these are set correctly, increase the InterPacketDelay. d. Stop the Job, and then create a new Job to read in new values for Packet Size and Interpacket Delay. Repeat process until you can run reliably. 5) AutoVISION AutoVISION can be used for a single camera. AutoVISION will always connect to channel 0 (camera 1). Trigger and Strobe can be set up from within the camera step. 5 - Getting Started with USB 3.0 Cameras Setting up USB 3.0 cameras is much easier than GigE. Image transfer into PC memory via USB 3.0 is much faster and more efficient, requiring far less PC involvement. There will be no dropped frames issues when using USB 3.0.
USB 3.0 cameras require that the JAI Virtual IF driver be installed for each USB 3.0 camera has been plugged into the computer. The directions to do this are shown in the following section. 5.1 - Connecting USB 3.0 cameras 1) Make sure the AVPBackplane is shut down 2) Connect all USB3 cameras to USB super speed ports on the computer. The ports are indicated with the following ICON on your PC. 3) If the camera and driver have already been installed on the PC, you should hear the Windows sound when plugging the camera in. Using Sentech STC-M Cameras with AutoVISION and Visionscape Page 18 of 35