4) You can check that the camera and driver have been installed successfully using the “Device Manager” a. Go to the USB Serial Bus Device section. Locate the camera. The cameras should appear with their full name. Example shown below. b. Right click on the device. You should see “device is functioning properly.” 5) If this is the first time an individual camera is connected to the PC, you will need to explicitly load the USB3 driver for it. This step must be performed for each camera that is connected to PC. a. To do so, please go to the start menu and run the “JAI Control Tool” utility b.
The GigE Vision Control Tool will discover all cameras connected to the PC, both GigE and USB, and display them in the list on the left hand side of the UI. c. For each USB camera, expand the + signs under the USB camera entry until you get to the Interface Layer d. Click on the popup to the right under Driver Installation to Install the USB Driver. e. Click on the button to execute. f. A DOS shell will open and driver install will be initiated g. Complete all prompts h. Exit the GigE Camera Control Tool application when all cameras are complete. 6) Delete dm.config file from the c:\omron\vscape\DM or c:\microscan\vscape\DM folder.
7) Start AutoVISION or Visionscape FrontRunner Using Sentech STC-M Cameras with AutoVISION and Visionscape Page 19 of 35