V460-H Industrial Handheld DPM Reader User Manual (EN)

Hardware Step 1 – Assemble the Hardware Connect the M12 Connector to the reader Connect the Ethernet Cable from IN port to Host PC Connect another end to OUT - POE injector! Part Description Part Number 1 V460-H Industrial DPM Reader V460-H0PX 2 Ethernet Communication Cable (Straight M12 Plug to RJ45 Connector) V430-WE-3M 3 Single Port PoE Injector, 30W, IEEE802.3at, 2 x RJ45 Connector, 90 to 264VAC 98-9000311-01 4 Standard Ethernet Cables, In-Cabinet Use XS6W-5PUR8SS100CM-G 5 AC Power cord 2.5M US C13 12-9000959-01

Стр. 2

Step 2 Connect to WebLinkHH • Navigate to Control Panel > Network and Sharing Center on your PC. • Click Local Area Connection . In the Status dialog, click Properties . • In the Local Area Connection Properties dialog, select Internet Protocol Version 4 (TCP/IPv4) and click Properties again. Set your PC to a 192.168.188.5 , for example. Note: In Windows 10, the Local Area Connection is referred to as Ethernet . Open a web browser and type the reader’s default IP address ( 192.168.188.2 ) in the web browser’s address bar. The reader will connect to WebLink HH .

Стр. 3

Step 3 Quick Setup When you click the Assisted Setup button in the Start view, a dialog with three lighting configurations will appear. WebLink HH generates your initial setup automatically. Once the setup is created, you can fine-tune its parameters in the Setup view too. Follow step 1 and 2 as below, • Auto Lighting is the default “auto-everything” that automatically selects the best lighting and imaging parameters for the application. • Torch Lighting only enables the built-in high-intensity long-range lighting and automatically selects the best Focus , Exposure and Gain parameters for codes to be read at a distance.

• Close-Up Lighting only enables the built-in Dome and Low-Angle lighting and cycles through illumination settings optimized to decode challenging direct part marks and/or codes on highly reflective surfaces.

Стр. 4

Step 4 Run Mode The sowftware will jump to Run mode, the right panel of the UI shows Counts for Cycles , Reads , No Reads , and Mismatches , as well as Rate information for Capture , Decode , Overhead , Total Read , and Trigger Rate , as well as Output Data . A "filmstrip" below the Image Area shows each image capture with a green check mark for a good read and a red x for a no read. Step 5 Setup Mode (Optional) The Decode area of the Setup view allows you to choose which symbology (code types) you want to enable and allows you to configure the parameters for that symbology. Click the symbols themselves to bring up a list of all the code types available in that symbology category.

Стр. 5