1 Setup of Camera & Software Vision Firewall settings Disable the security settings for the Ethernet port to which the camera is connected. 1-2-5 Setup of camera connection Setup the camera connection following the steps below. 1 Connect the camera cable (Power, I/O) to DC 12V power source. Additional Information For wiring, refer to the instruction manuals. 2 Connect the camera cable (LAN) and camera cable (Power, I/O) to FJ camera, and turn on the power. 3 Launch IP Configuration Tool by double-clicking the shortcut. 4 Make sure the FJ camera is listed on Model Name . In case no camera is listed, click Refresh button, and check that camera appears on the list.
(In some cases, it takes approximately 30 seconds for detecting camera connection. If no cam- era is listed, click Refresh button after waiting for a while.) 5 Check Persistent IP on IP Configuration Protocol , and set the value below to Persistent IP Address . Click Save button and close the program. 1-10 FJ Series (Camera & Software Vision Package) PC Vision System Camera Setup Guide (Z428-E1) Item Value IP Address 192.168.1.2 Subnet Mask 255.255.255.0 Default Gateway 0.0.0.0