3.5.2. Configuring the Camera Image Input AOS Set the imaging position, shutter speed, camera gain, and measurement range of Z so that the camera calibration target can be measured properly. Make sure that the warmup of the 3D vision sensor is completed before you perform the procedure below. 20 2 Hardware preparation: Place the camera calibration target so that the following conditions are met. • It is seen that the 3D vision sensor is placed directly above the center of the camera calibration target. • It is seen that the optical axis of the 3D vision sensor forms an angle of 90 ± 5 degrees with the plane of the camera calibration target. There are two methods of movement, for example. 1.
Move the 3D vision sensor attached to the camera stand. 2. Move the camera calibration target with the 3D vision sensor fixed. Step Description Window image, diagram 1 In the main window, click the 0. Camera Image Input AOS icon to open the setting window. ▼