Resume Cleanup Update the Firmware If the robot vacuum starts running low on battery during a cleaning task, it will automatically return to the charging dock to recharge, then resume cleanup where it left off after being charged sufficiently. You can update the firmware via the app. Before updating, make sure the robot vacuum is on the charging dock and has at least 15% battery left. Restart the Robot Vacuum Pause If the robot vacuum stops responding or cannot be turned off, press and hold the button for 15 seconds to forcefully turn it off. Then press and hold the button for 3 seconds to turn the robot vacuum on.
While the robot vacuum is running, press any button on the robot vacuum to pause it, and then press the button to resume the cleaning. Pressing the button will end the current cleaning task and send the robot vacuum back to the charging dock. Restore Factory Settings Note: Do not pick up or move the robot vacuum while it is paused, so as to avoid navigation errors that could prevent the robot vacuum from returning to the charging dock or cause the loss of map. If the robot vacuum does not function properly after being restarted, you can use a pin to press the reset button until you hear a voice to indicate that the robot vacuum is restoring factory settings.
This will reset the robot vacuum to its original factory settings. Sleep Mode The robot vacuum will automatically enter sleep mode after it is paused for 10 minutes, and its indicator will go out. To wake it up, press any button on the robot vacuum. Note: If the sleep time exceeds 12 hours, the robot vacuum will be turned off automatically. 10