How to Install Installing the Batery Installing the 2-in-1 Charging & Storage Mount Slide the vacuum cleaner along the batery track until it clicks into place. Note: Afer installing the batery, press the power buton to turn on the vacuum cleaner. • The 2-in-1 charging & storage mount should be installed in a cool and dry place with an electrical outlet nearby. Prior to installing, ensure that there are not any wires or pipes in the wall directly behind where the mount will be installed. • The botom of the 2-in-1 charging & storage mount should be at least 115 cm from the ground. • Select a suitable installation place and mark the positions of the mounting holes on the wall.
• Use a power drill with an 8 mm drill bit to drill a hole approximately 40 mm deep in each marked position, then insert a wall plug into each hole. • Align the mounting holes on the 2-in-1 charging & storage mount to the holes on the wall, then atach the mount to the wall using the included screws. Click into Place Hold the vacuum cleaner in one hand and grasp the batery in the other hand, then press the batery release buton and pull the vacuum cleaner in the direction shown to separate it from the batery. Removing the Batery 5 115 cm