Filter Side Brush To clean the filter in the dust compartment and 2-in-1 dust compartment with water tank, remove it as indicated in the diagram. It is recommended to replace the side brush every 3–6 months for optimal cleaning effectiveness. Periodically remove and clean the side brush. • Afer rinsing the filter with water, make sure it is thoroughly dry when reinstalling the filter into the dust compartment or 2-in-1 dust compartment with water tank. • To prevent the filter from becoming clogged, it is recommended to regularly clean the filter using the cleaning brush. • It is recommended to replace the filter every 3 to 6 months.
Brush Clips Brush Cover Brush Clean the cliff sensors every three months using a sof cloth. Cliff Sensors Brush Bearing 1. Flip the vacuum-mop over and pinch the clips to remove the brush cover. 2. Remove the brush and the brush bearing. 3. Use the cleaning brush to clean the brush. 4. Reinstall the brush and its bearing, then put back and press down the brush cover until it locks into place. Cliff Sensors Note: It is recommended to replace the brush every 6–12 months for optimal cleaning effectiveness. 11