Replacing the Filter Daily Care & Maintenance Warning: Make sure the purifier is turned off and the power cord is unplugged before replacing the filter. Notes: · To avoid injuries, do not put your fingers between the upper and filter compartments when replacing the filter. · Unpack the new filter before replacing the old one. Warning: Make sure the purifier is turned off and unplugged before performing the following operations. Cleaning fan blades and air duct Opening the filter compartment 1 Replacing the filter 2 · Open the plug, loosen the screw inside it with a screwdriver, and rotate the grille clockwise to remove it upwards.
· Use a vacuum cleaner to remove any dust from the air duct and fan blades, or wipe the dust off gently with a soft cloth. · Use a brush or soft cloth to gently wipe the plasma generator. · After cleaning, rotate the grille counterclockwise to install it. Tighten the screw with a screwdriver, and close the plug. Remove the old filter upwards and place the new filter into the filter compartment. Then reinstall the upper compartment. The dirt may rise in the air when removing the old filter, and it is recommended to wear gloves and a mask before replacing the filter. Then put the old filter into a plastic bag, and secure the bag before discarding it.
If you come into physical contact with dust, wash it off with water instead of wiping it off. Press and hold the release buttons with both of your hands to separate the upper compartment from the filter compartment. Align the filter with the clip on the purifier to install it. Plasma Generator Note: This purifier is compatible with the model AFEP7TFX19 filter. Note: To avoid damaging the purifier, do not rinse or spray the air duct and fan blades directly with water, or wipe them with a soaking wet cloth. 8